What Happens on a Spin Training Flight in 2026: Step by Step

What Happens on a Spin Training Flight in 2026: Step by Step


Published on:

Updated on:

Read time:

8 min read

The nose drops. The horizon slides sideways across the windshield and keeps going, and for a second the ground seems to turn beneath you like a record. Then your hands and feet do exactly what you rehearsed on the ground, the rotation stops, and you ease the airplane back to level flight. That is a spin training flight. For a spin training pilot who has rehearsed each step, the real thing is often calmer than the version imagined the night before.

If you are working toward your CFI, you need spin training before your checkride, and it helps to know what happens before you strap in. This guide walks through one flight in order: the briefing, the preflight, the climb, the stalls, the entry, the spin itself, the recovery, and the logbook endorsement. You will see how your instructor keeps every step controlled, so you can arrive at our CFI Spin Endorsement day ready to learn instead of bracing for it.

Your Briefing Turns the Unknown Into a Plan

Every spin flight starts at a table. At Blue Skies Above, our package opens with ground instruction: spin aerodynamics, how stalls become spins, recognition and prevention, the recovery procedure, and how you will one day teach all of it to your own students.

The core idea fits in one sentence: a spin is an aggravated stall. The FAA’s Airplane Flying Handbook explains that an airplane must be both stalled and yawed to spin, and that at least one wing stays stalled the whole time. Once you can picture that, each control input in the air has an obvious job.

Your instructor will also brief the airplane itself. The handbook describes a generic recovery procedure, but the procedure in the airplane’s Pilot’s Operating Handbook (POH) always comes first. The POH and your instructor set the exact altitudes, limits, and steps for the flight you are about to fly.

The briefing also covers when to stop. You agree on who has the controls, the words you will use to hand them over, and how either of you will call an end to a maneuver. If you want the rule behind the training, our spin endorsement requirements guide covers 14 CFR 61.183(i) in detail.

Preflight and Weight and Balance Get Extra Attention

Spins put unusual demands on the airplane, so the walkaround gets a little more careful. The handbook calls for a thorough preflight with special attention to loose items in the cabin, anything that could shift and change the center of gravity (CG), and the control cables. Slack rudder or elevator cables could keep you from getting full anti-spin control movement.

Inside, you will clear the back seat and baggage area, because the handbook warns that even small weight or balance changes can change how an airplane spins and recovers. Some airplanes are approved for spins only in the utility category, with tighter weight and aft CG limits. An airplane approved for spins in the utility category but loaded to normal category limits may not recover from a spin that goes past one turn.

So you and your instructor run the weight and balance numbers together and check them against the POH limitations and placards. Spin approval comes from the manufacturer, through the POH, placards, and type certificate data, and the training must be flown in an airplane certificated for spins. Our spin endorsement package uses our 180hp Cessna 172.

Climbing High and Clearing the Sky Below You

Next comes the climb, which runs longer than a normal lesson climb because altitude is your margin. The handbook’s rule of thumb is that the first turn of a spin costs roughly 1,000 feet, and each turn after that costs about half as much.

Two figures are worth knowing. The handbook’s general guidance is to start every spin high enough to finish the recovery at or above 1,500 feet AGL (above ground level). On the CFI checkride, the Airman Certification Standards (ACS) ask for an entry altitude that lets you finish the task no lower than 4,000 feet AGL. Your instructor will pick the training altitude for the day with those numbers, the POH, and the weather in mind, and will tell you what it is before you climb.

At altitude, you clear the area above and below. Clearing turns let you both look for traffic in every direction, including the airspace you are about to descend through. Clearing is also an ACS skill, so get in the habit of doing it out loud.

Two smiling pilots, one holding a signed document, standing beside Blue Skies Above Cessna N717G
Student with a family member after checkride. (Source: Blue Skies Above media archive)

Stalls First, Then the Incipient Spin

You will rarely go straight into a full spin. The handbook suggests that it can help to start with power-on and power-off stalls in a clean configuration so you learn how this airplane behaves as it stalls and recovers. These are the same stalls you practiced during commercial pilot training, and a few clean ones loosen your hands and remind you that the airplane is predictable.

From there, many instructors move to an incipient spin, the first phase of rotation right after the stall. The handbook calls incipient spins, recovered before they fully develop, the most commonly used maneuver in initial spin training. You let the airplane start to rotate, then recover before it completes a full turn. You get a short taste of the motion before committing to more.

During this phase, the airspeed settles low and steady. Your eyes go to the turn coordinator, whose small airplane shows which way you are turning. The slip-skid ball is not a reliable guide here, because its movement depends on where it sits in the panel.

The Entry, Step by Step

Once incipient spins feel familiar, your instructor demonstrates a full spin entry, then hands the airplane to you, the same demonstrate-then-practice flow we use across our CFI Spin Endorsement day. The handbook’s generic entry looks a lot like a power-off stall:

  1. Reduce power to idle slowly while raising the nose to a pitch attitude that ensures a stall.
  2. As the stall arrives, smoothly apply full rudder in the direction you want to spin.
  3. At the same time, bring the elevator full back to its stop and hold it there.
  4. Keep the ailerons neutral, unless the POH says otherwise.

The two most common entry mistakes are not enough rudder and not holding the elevator all the way back. Either one tends to turn the maneuver into a spiral instead of a spin, and your instructor will point it out right away.

What You See and Feel in a Developed Spin

The engine is quiet at idle. The nose is well below the horizon, the windshield is full of fields and trees, and the world rotates around a point ahead of you. Your instructor may count the turns out loud, which gives your brain something steady to hold on to.

In a developed spin, rotation rate, airspeed, and descent rate settle into a steady pattern on a nearly vertical path. The handbook notes that some training airplanes do not fully develop a spin and can transition from the incipient phase into a spiral dive instead. You can tell the two apart by airspeed. In a spin the airplane is stalled, so airspeed stays low and constant. If the airspeed is climbing, you are no longer in a spin.

Some pilots feel a pull of disorientation, and some feel queasy after several spins. Tell your instructor when you feel it. Pausing, flying straight and level for a while, or saving the rest for later is a normal part of spin recovery training, and spin skills build better when you are comfortable. Our post on why spin training matters for new instructors explains why that calm is worth building.

The Recovery Steps You Will Teach One Day

To recover, you follow the manufacturer’s procedure in the POH. When a manufacturer gives no procedure, the handbook offers a six-step template. Many instructors teach the first four steps with the memory aid PARE: Power, Ailerons, Rudder, Elevator. It is the sequence you will later teach as a certified flight instructor.

StepActionWhy it helps
1Power to idlePower can flatten the spin and speed up rotation
2Ailerons neutralAileron input either way can delay recovery
3Full opposite rudder, heldRudder is usually the most important control for stopping rotation
4Elevator briskly forward of neutralLowers the angle of attack so the wing unstalls
5Neutralize the rudder once rotation stopsPrevents a yaw or slip as speed builds
6Smooth back pressure to level flight, adjust powerReturns you to level flight without a secondary stall

New pilots tend to miss two details. First, the forward elevator comes right after full rudder; you do not wait for the rotation to stop. Second, the inputs should be brisk and positive. Slow, cautious movements can let the spin continue. Again, the POH for the airplane you fly has the final word on the steps.

The Pull-Out and Spins in Both Directions

When rotation stops, you neutralize the rudder and ease back toward level flight. You will feel the seat press up under you as the nose comes up. The handbook warns against two opposite errors here: pulling too hard, which can cause a secondary stall, and pulling too little, which lets airspeed build. Your instructor watches the airspeed and G load with you.

Then you climb back to altitude and do it again, this time the other direction. Spins to the left and right can feel different, and your future students will need you to handle both. Over the flight, the day moves through multiple spin scenarios, from demonstration to your own entries and recoveries, until they are consistent. Our spin endorsement includes up to 2 hours of flight time, so there is room to repeat what needs repeating.

Student pilot and instructor sharing a high five on the ramp in front of a Cessna and the Lanett airport hangar
Back on the ramp at Lanett, the debrief turns the flight into lessons you can teach. (Source: Blue Skies Above media archive)

Debrief, Endorsement, and What Your Day Includes

Back on the ground, the debrief connects the flight to your future teaching. You talk through what you saw, which errors showed up, and how you would explain each phase to a nervous student of your own. Our post on why spin training is essential for every CFI explains why that teaching angle matters.

Once your instructor finds you competent, you receive the logbook endorsement required by 14 CFR 61.183(i). On checkride day, the examiner may accept it as evidence of your spin proficiency, except on a retest for spin-related deficiencies. One related rule: the parachute requirement in 14 CFR 91.307(c) does not apply to spins required for a certificate or rating when a certificated flight instructor gives the training. Our spin training for CFIs FAQ answers the quick questions.

Instructor and student shaking hands beside a Cessna 172 while the student holds a signed document
Paperwork done the right way: every endorsement carries your instructor's signature and certificate details. (Source: Blue Skies Above media archive)
Package detailWhat you get
CFI Spin EndorsementGround instruction, up to 2 hours of flight in our 180hp Cessna 172, flight instruction, and the logbook endorsement, in 1 day
Certified Flight Instructor (CFI)The certificate this endorsement prepares you for

The day is priced at $399, and our guide to what a CFI spin endorsement costs in 2026 breaks down what moves that number. If you are planning the full CFI path, financing through Stratus Financial and Flight Training Finance is available to qualified applicants; see our financing options.

Book Your Spin Training Flight in Lanett

You learn spins one step at a time, with an instructor beside you and plenty of air below. When you are ready to fly yours at Lanett Municipal Airport (7A3), contact us to book your spin endorsement day.

Back to all articles

Similar topics

Related Posts